|
|
Toll Free: (877) 876-5247
Welcome to #A3200 Support!
(4-in-1 Mobile
Air-Conditioning Unit, Model# A3200)
_______________________________________________________________
(Click
Picture to Enlarge)
Features
_______________________________________________________________
(Click
Picture to Enlarge)
Control
Panel
-
Power
On/Off Button - Toggle
button! Push to START and push again to STOP. When it is on, the
Power Indicator (on the left) is lit.
-
Mode
Button - Toggle Button! There are four
modes to choose from: Cooling, Dehumidifying, Heating, and Fan. There is
an indicator (on the left) for each mode. When it is on, it indicates
that mode is active exclusively.
-
Fan
Speed Button - Toggle Button! When it
is on Cooling, Dehumidifying, Heating, or Fan mode, there are three
speeds to choose from: Low, Medium, High. There is an indicator for each
speed. When it is on, that speed is active exclusively.
-
Rhythm
Button - On/Off Button. When it is
ON, the fan will similate a natural breeze with rhythmic pattern
(recurrent strong and weak wind).
-
Timer
Mode Button - Press this button
before you start setting up On or Off time for the unit to Start or Stop
operating.
-
Timer
Button - 
The maximum time to set the
unit to turn on or off by itself is 7.5 hours. When the unit is running,
pushing this button will set the time to turn it OFF. When the
unit is not running (but plugged in), pushing this button will set the
time to turn it ON. Every time you push the Timer button, you will increase or decrease the time to turn
on or off by 1/2 hour increment respectively.
-
Louver
Button - Toggle Button! You can choose
On or Off by pushing the button once. When it is ON, the louver swings automatically and horizontally.
-
Drain
Tank Indicator - When it is time to
empty the drain tank, it will light up and a buzzer will sound alerting
that emptying is required. At such time, the compressor will switch off
and the unit will turn itself into FAN mode. Take out the water tank and
empty all the water. Push the tank back in after emptying will switch
the compressor back on after about 2-3 minutes. The unit will return
back to the previous mode.
_______________________________________________________________
(Click
Picture to Enlarge)
Troubleshooting
Blinking
Indicator
It is normal to have blinking
indicator when you are switching between features (Cooling, Heating, Dehumidifying,
and Ventilating). The unit will take a few minutes for it to adjust/switch
from one function to another. Note: blinking water tank
indicator means emptying is needed.
The unit does not operate
at all
-
Has the wall outlet it
plugged into failed? Use another outlet instead!
-
Is the plug dislodged from
the outlet? Pull it out and re-insert!
-
Was there a power surge? If
yes, you need to re-set the circuit breaker in one of your house
electrical sub-panels (professional help may be required).
-
Is the Drain Tank Indicator
lit? If yes, emptying is required. See
above for detail!
-
Check to see if the water
tank is properly and correctly placed. Click
here for detail.
-
Is the timer set correctly?
See above!
-
If all the the above is
checked and the unit is still mal-functioning, please email us for online support.
Water Leak
-
Pull out the water tank to
check the water sprout inside if it is right on top of the tank.
Sometimes, the sprout is knocked out of position during shipping and by
accident.
-
Check the side by-pass outlet
to see if there is any debris blocking the dripping passage. Remove
debris if necessary!
-
Make sure the unit is on
level surface. Sloping surface will upset the dripping process and
overflow may occur.
-
If all the the above is
checked and the unit is still mal-functioning, please email us for online support.
Cooling is not functioning
efficiently
-
Is any outlet or inlet
blocked? See above!
-
Are there too many
appliances and computers operating at the same time in the room? Turn
off some of them!
-
Are air filters dirty?
Clean
the filters once every two weeks if possible. (See Maintenance
also).
-
Is the timer set correctly?
See above!
-
Set the Fan Speed at
"High"!
-
If all the the above is
checked and the unit is still mal-functioning, please email us for online support.
Too much noise and
vibration
-
It is normal for the
refrigerant inside to make noise and the system to vibrate. As long as
it is within limit and temporary, it is okay.
-
Is the unit inclined?
If yes, turn off the unit and put it on a flat surface and wait about
5-10 minutes before turning it back on.
-
If all the the above is
checked and the unit is still mal-functioning, please email us for online support.
The unit turns on and off
by itself frequently
-
Is the power voltage
fluctuating in your house? Check with your utility company.
-
Is the air exhaust duct not
installed correctly. Please click here
to see the correct installation.
-
Did you add any
unauthorized air exhaust duct to the one shipped? If yes, your
warranty may be void and you may incur permanent damage to the unit.
Please click here to see the correct
installation.
-
If all the the above is
checked and the unit is still mal-functioning, please email us for online support.
_______________________________________________________________
(Click
Picture to Enlarge)
Circuitry 
This detail
circuit diagram is intended to be used as reference only. Any unauthorized
use of this diagram and its technical design is prohibited. Manufacturer (GREE)
Model # is CF0.5DIIU/11156.
_______________________________________________________________
|
